Printout Header
LEX RSS Feed

LEX Online Manual Content

Compare Window Command Buttons

The command buttons in the object compare mode

Reload directory info button The Reload attribute info button refreshes the attribute list from the LDAP server.

Add new attribute button The Add new attribute button adds a new attribute value to the currently selected LDAP object.

Add attribute element to an array button The Add attribute element to an array button can add a new value to an multi valued attribute. You cannot use this button if you have selected a single valued attribute.

Remove attribute button The Remove attribute button deletes an attribute value from the currently selected LDAP object.

Show only attributes that have values button The Show only attributes that have values button toggles the display between the "full attribute range" view and the "used attribute only" view. In the "full attribute range" view, all attributes of an object are shown, regardless whether they have values or not. This button is deactivated when LEX cannot use the directory schema of the LDAP server. This setting affects both object panels.

Show friendly object names button The Show friendly object names button creates a user-friendly output of names for the DN attributes which was configured to be shown as RDNs. This setting affects both object panels.

Show distinguished name in Novell notation button The Show distinguished name in Novell notation button shows the distinguished name attributes in Novell's dotted notation. This setting affects both object panels.

Show hex output for attribute with hex values button The Show hex output for attribute with hex values button toggles the display for attributes which data type has binary character (hex values / octetstring values). This refers to the object list as well as to the attribute list. The values are shown as their hexadecimal values OR as their corresponding ASCII characters. This setting affects both object panels.

Show multivalued attributes The Show multivalued attributes button toggles the display for attributes which contains an array of values. Normally such multi valued attributes are displayed condensed
Multivalued attributes condensed display
If you choose to show all such attributes with all values, activate the button and the display changes to
Multivalued attributes full display
This setting affects both object panels.

Show friendly object names button The Set attribute filter button lets you configure the filter which affects the attribute list display. This display can be filtered in an excluding (don't show this attributes) or an including (show only this attributes) way.

Active filter button If an attribute list filter is active, the Set attribute filter button is blinking to attract attention to the fact that maybe not all attributes are shown in the current list.